Parts List - Costway TQ10020DE Handbuch

● Overcharging or undercharging the battery may shorten battery life and
decrease vehicle running time.
● After the first charge, recharge the battery for at least 8-10 hours after
each use. Never charge the battery longer than 24 hours. Charge the
battery after each use, regardless of how long the vehicle was used.
● The battery must be upright while charging.
● Do not allow the battery to run down completely before charging.
● Charge the battery before storing the vehicle.
● Charge the battery at least once per month, even if the vehicle has not
been used.
● Leaving the battery in a discharged condition will ruin it.
● If the vehicle will be stored for more than two months, be sure to
disconnect the motor harness from the battery.
● Do not store the battery in temperatures above 40℃ or below-6℃.
● Prevent the battery from moving freely inside the battery compartment.
Make sure all screws for battery tray tighten.
● Examine the battery, charger and its connector for excessive wear or
damage each time you charge the battery. If damage is detected, do not
use the charger or the battery until you have replaced the worn or
damaged part.
● Remember to remove an exhausted battery from the vehicle.
● Battery leakage and corrosion can damage the vehicle.
Disposal
● Your battery is a sealed lead-acid battery
It must be recycled or disposed of it in an environmentally sound manner.
● Never dispose your battery in the regular, household trash. The
incineration. Land-filling or mixing of sealed lead-add batteries with
household trash is prohibited by law in most areas.
● Always remove exhausted batteries from your toy.
● Dispose of dead batteries properly. Never burn or bury them.
● Do not dispose of a lead-acid battery in a fire. The battery may explode or
leak.
12
TO PROLONG BATTERY LIFE, YOU MUST RECHARGE THE BATTERY AFTER
EACH USE. YOU MUST ALSO CHARGE YOUR BATTERY IF IT HAS NOT
BEEN USED FOR 30 DAYS OR MORE.

Parts List

● Please identify all parts before assembly and save all packaging material
until assembly is completed to ensure that no parts are discarded.
● Metal parts have been coated with lubricant for protection during shipment.
Wipe all metal parts with a paper towel to remove any excess lubricant.
Main body x 1 Handlebar x1
Front Wheel x1 Rear Wheel x2
Front Fork Decoration
Front Fork x1
WasherX 4
Nut X4(M8)
(8*22*1.3mm)
Bolt x 1(M5X30) NutX1 (M5)
Windshield x1
Front Axle x1 Rear Axle x1
Socket Tool x2
x2
Screw x1 Motor Cover
(4*12mm) Decorations x2
MANUAL
Manual x1 Charger x1
EN
13