Costway TQ10020DE Handbuch Seite 13

Remote Control Instruction
(1). Supply Voltage---DC 3.0V , Battery 2*1.5V AAA (not included)
(2). Frequency 2.407GHz-2.473GHz (Peak output power: 5dBm)
(3). Instructions
Forward
Speed
Back
a. First time using needs to match code. This product has memory function.
Replacing battery is unnecessary to match code.
b. Hold down " △ "& " ▽ " keys for 3 seconds to start matching code. The
first LED flickers.
c. Turn on the car body power now. The first LED lights up, and match code
successfully.
d. Remoter not running for 10 seconds will be standby. Press any key to wake
up.
e. Keys caption: " △ " Forward, " ▽ " Back, " ◁ " Left, " ▷ " Right, " S "
Speed, " P " Brake.
Press " S " key to set up speed, 1 LED lit up is low speed, 2 LED lit up is
medium speed, 3 LED lit up is high speed, Reversing is only at a low
speed.
Press " P " key to hold the brake, All LED lights flicker.
※ The remote controller only can be used with adult's guidance.
24
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
Brake
However, there is no guarantee that interference will not occur in a particular
Right
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Left
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Speed display
Connect the equipment into an outlet on a circuit different from that
connected to the receiver.
Consult an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by
the part responsible for compliance could void the user's authority to operate
the equipment.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
EN
25