Costway TQ10020DE Handbuch Seite 10

Maintenance
● Clean with a dry, soft cloth only. Do not wash With water or corrosive
material.
● Store vehicle in a dry area when not in use, since moisture could cause the
metal components and electrical parts to corrode.
● Remember to charge the battery monthly while the vehicle is not in regular
use.
● Check and tighten all screws and coverings regularly
● Check all plastic parts for cracks. Replace as necessary.
Troubleshooting
Problem Possible Cause
Car cannot Circuit breaker tripped
move
Loose wire or
connectors
18
Solution
Circuit breaker may "trip" and stop the
vehicle if it is overloaded or the driving
conditions too severe. The breaker will
automatically reset after approximately 10
seconds, and the vehicle will operate
normally. To avoid repeated automatic
shut downs, do not overload the vehicle by
exceeding the weight limited of 25kg
(55lbs). Or by towing anything behind the
vehicle. Do not drive up hills or run into
fixed objects,which can cause the wheels
to stop spinning while power is still being
supplied to the motors.
Check all wire and connectors .Make sure
that the motor connector is plugged in
tightly to the battery, and that there are no
loose wires around the motor.
Problem Possible Cause
Car cannot Dead battery
move
Undercharged battery
Charger is not working You must have a volt meter in order to tell
Damaged switch
Car was Loose wire or
running but connectors
suddenly
stopped
Solution
An old or improperly cared battery may be
dead, If you are unsure whether it is dead
or not, you can have it tested at your
service Center.
A new battery should have been charged
for at least 12 hours before using the
vehicle for the first time, After that, it must
be recharged for at least 8-10 hours after
each use. Never charge longer than 24
hours. Check all connectors, make sure the
charger is plugged into the socket.
whether the charger is working or not. If
you think there may be a problem with the
charger, take it to the Service Center
where they will test it for you.
When exposed to water or moisture, switch
can become corroded, or can jam due to
loose dirt , sand, or gravel.
Contact your service Center for diagnosis
and repair.
Check all wire and connectors. Make sure
that the motor connector is plugged in
tightly to the battery, and that there are no
loose wires around the motor.
EN
19