Manual
MODSTER Blizzard GPS
13. Compass Calibration
Compass calibration consists of two steps:
Step 1:
After the aircraft is successfully paired, place it on a flat surface, press the
geomagnetic calibration button to turn the aircraft as indicated in the pic-
ture, rotate it horizontally for about 3 circles, and the remote control beeps
until the indicator light stays on after the aircraft.
Step 2:
Put the nose of the aircraft up and „upright", as shown in the figure below,
rotate the fuselage about 3 times and the remote control beeps until the
front indicator of the aircraft is always on, and the compass calibration is
completed
Note: If the compass of the drone is messed up and
the drone is unlocked without calibration, the drone will
be enabled to protect the program and cannot take off
32
www.modster.at