Important Warnings - l&l AR330500TC Installationsanleitung

INSTALLATION INSTRUCTIONS
"Stand-alone/master with external push button" mode
The function mode of "stand-alone/master with external push button" is similar to the previous one. In fact even in this case the
device automatically reproduces an Easy Run show and runs it at the set speed. Moreover, the running of the show can be con-
trolled by an external push button which must be connected to terminals PB and L.
The remote external push button operates as follows:
• A short pressure on the push button stops/starts the light show.
• A long pressure on the push button turns on/off the units connected to AR330500TC.
To set the "stand-alone/master with external push button" mode:
• Connect the external push button to terminals PB and L of the power supplì terminal board
• Put dip-switches 10 and 11 into the ON position.
Example 1
Device in stand-alone/master mode with: sequence colour number 0, running speed number 4 and
external push button enabled.

IMPORTANT WARNINGS

•
•
•
•
•
L&L Luce&Light srl / Via Trescalini, 5 / 36031 Dueville, Vicenza / Italy / T +39 0444 36 05 71 / F +39 0444 59 43 04
Make all connections with the device off.
Class I unit: categorically needs grounding.
Wiring and connections must be carried out by qualified personnel.
Install the device in a well-ventilated place.
The device generates heat when in function.
E lucelight@lucelight.it / www.lucelight.it
AR330500TC
OFF
ON
1 12
1 12
7/8