l&l AR330500TC Installationsanleitung Seite 5

INSTALLATION INSTRUCTIONS
In DMX function mode
Dip-switch 1-9 Attribution of DMX address
Dip-switch 11 Selection DMX mode
Dip-switch 12 Termination Resistance
In stand-alone/master function mode
Dip-switch 1-4 Selection of running speed of the show
Dip-switch 5-8 Selection of the show
Dip-switch 9-11 Selection mode with or without external push button
Dip-switch 12 Always Off
Function modes
The driver has three different function modes, which can be selected by attributing different configurations to the dip-switches
from number 9 to number 12 of the DIP2 group.
Name mode
DMX
Stand-alone without external button
Stand-alone with external button
"DMX" mode
In the "DMX" mode the function of the device is controlled by data sent by a console or an external recorder. AR330500TC is
controlled with 3 DMX channels to which the RGB outputs are interlinked for LED control, the 3 control channels operate on the
outputs as shown in the following table.
Base channel RED
Base channel + 1 GREEN
Base channel + 2 BLUE
To set the "DMX" mode:
• Put dip-switches 10-11-12 of the DIP2 group into the OFF position.
• Set the DMX address inside the system under the
controller which has been assigned to control of the device in question (base channel). Each device is ready to receive an
address from between number 1 and 511. The address is set with dip-switches 1-2-3-4-5-6-7-8-9 ; this ON /OFF sequence
can be seen as a 1/0 sequence, that is as a binary number. The table on page 8 allows each of the binary configurations of
the nine dip-switches to be univocally associated to the corresponding number between 1 and 511.
Note: DMX channel number 1 is selected both if binary number 0 is set and if number 1 is set (DMX channel zero does not exist).
• Insert (if necessary) DMX line termination resistance by putting dip-switch 12 into the ON position.
In this function mode any DMX devices connected to the output of the device must be managed as independent units in a DMX
chain connection (daisy-chain).
In the DMX mode it is possible to check the quality of the DMX data connection by means of the red LED on the side of the
dip-switches:
- If the LED is off this means that the DMX signal is not present
- If the LED flashes the DMX signal is correct
- If the LED emits just two short flashes, the DMX cable is inverted or faulty.
Example 1
Device in "DMX 3 channels" mode with DMX address "1" and outputs controller by 3 channels; termi-
nation resistance not inserted.
Both configurations are valid because the DMX "0" address does not exist and is made to coincide
with address "1".
Example 2
Device in "DMX 3 channels" mode with DMX address "64" and outputs controlled by 3 channels;
termination resistance inserted.
L&L Luce&Light srl / Via Trescalini, 5 / 36031 Dueville, Vicenza / Italy / T +39 0444 36 05 71 / F +39 0444 59 43 04
9 10 11 12
- 0 0 0
n.u. 0 1 0
n.u. 1 1 0
control unit. The DMX address is the number of the first channel of the
E lucelight@lucelight.it / www.lucelight.it
AR330500TC
DMX CH.
3
-
-
1
OFF
ON
1 12
OFF
ON
12
OFF
ON
1 12
5/8