Wiring Diagrams - l&l AR330500TC Installationsanleitung

INSTALLATION INSTRUCTIONS
• Dimmable electronic driver with current output for power LED, with 3 outputs (RGB).
• It's possible to connect to each output from 1 to 6 in series LED.
• Active Power Factor Corrector.
• IP20 independent driver, for indoor use.
• Can be used with the DMX 01 control units,
• Supplied with terminal cover and cable retainer.
• Opposite input and output terminal blocks (terminal area 2,5 mm2).
• 8 bit PWM dimming control.
• Isolated DMX line.
• Features of the DMX regulation:
- Standalone mode with 16 light show and 5 cycle speeds set by dip switch. Possibility to use a push connected to the pri-
mary side to stop and start cycle and switch on and off;
- DMX mode based on DMX 512 Standard. Dipswitch for setting Dmx address and line termination resistor;
- LED indicator of the state of DMX trasmission and show speed;
- Quarz for 8 hour syncronized show without DMX connection.
• Double terminal blocks to loop other units.
• Clamping screws on primary and secondary circuits for cables with diameter: min. 6 mm - max. 9 mm.
• Driver can be secured with slot for screws.
• Protections:
- against overheating and short circuits;
- against mains voltage spikes;
- against overloads.
• Can be switched on and off on secondary circuit for power LED.
• Suitable for the supply of Power LED.

Wiring diagrams:

Power supply
external button
L
V in
N
N
L
PUSH
PUSH
L&L Luce&Light srl / Via Trescalini, 5 / 36031 Dueville, Vicenza / Italy / T +39 0444 36 05 71 / F +39 0444 59 43 04
L
N
N
L
PB
Input
_
B
+ _
G
+ _
R
+
_
GND
+
GND _
+
E lucelight@lucelight.it / www.lucelight.it
1 12
DATA ON
Dip switches for
DMX address
IT IS RECOMMENDED TO INSTALL A SWITCH
LED
IN THE PRIMARY CIRCUIT.
LED
IN THE EVENT OF A FAILURE AND FOLLOWING
RECOVERY THE MAINS, THE FIXTURE STARTS
LED
TO OPERATE EVEN IF IT WAS PREVIOUSLY
TURNED OFF WITH THE SYSTEMS PRESENT IN
THE DEVICE (for example button NA).
DMX
In case of prolonged disuse is good practice to turn
off the controller interrupting the mains voltage.
AR330500TC
Constant current
output for LED
Output DMX
signal
Input DMX
signal
2/8