Yamaha Wi-TUNE Bedienungsanleitung Seite 8

Using the Tuner stand
Setting the ID after replacing
the Transmitter
The ID setting data is shared by the Tuner and
Transmitter. This is done to prevent signal
scramble during wireless communication.
An ID was programmed into the Tuner and
Transmitter supplied in this Wi-Tune package
before they shipped from the factory.
If you are using a different Transmitter (that
was not included in this package), you must set
the ID on that Transmitter.
8
1. Gently press down and slide the cover on
the right side of the Tuner to remove it.
2. Slide the Transmitter into the Tuner so that
the Transmitter will lock into the Tuner's
connector.
3. Turn on the power to the Transmitter and
Tuner.
You can do this while the power to each
unit is turned on.