Maintenance; Storage - Falo 8 kW Gebrauchsanleitung

MAINTENANCE

IMPORTANT! BEFORE PERFORMING ANY TYPE OF MAINTENANCE, MAKE SURE THE
GAS SUPPLY TAP AND/OR BURNER SUPPLY TAP ARE CLOSED.
Maintenance concerns:
Cleaning the inside of the glass pipes: use a non-metal pipe-brush (optional) to remove traces
of dirt and/or soot.
IMPORTANT! Dry clean with a soft cloth. The use of liquid products could create depo-
sits and/or encrustations that are hard to eliminate.
- Cleaning the outside of the appliance (use a soft cloth and neutral cleaning products and
avoid pouring these directly on the part to be cleaned).
- Control or replacement of the rubber gas hose (max L = 1.5m), whenever damaged and
according to the schedule provided by Laws and Standards applicable in the Country of use.
- Checking the integrity of all the parts making up the appliance; in case of wear or breakage,
only replace with the Manufacturer's original spare parts.
- replacing batteries for electronic ignition (Fig. 4: 3) or in the Remote Control unit (Fig. 4: 3).
NOZZLE REPLACEMENT (by professionally qualified personnel)
1 – Remove the tank cover side panel (Fig. 3: 15);
2 – Loosen the retention screws (Fig. 7: 1) of the tap and burner drawer (Fig. 7: 2).
3 – Move the burner unit (Fig. 7: 4) so as to make the nozzle accessible.
4 – locate the nozzle (Fig. 7: 5), unscrew it delicately from its housing, and replace it, being
VERY CAREFUL NOT TO DAMAGE THE THREADED PARTS.
5 – Fit the new nozzle back on (always for the same type of gas) and delicately fully tighten.
6 – Fit everything back on in the reverse sequence.
IMPORTANT! The appliance MUST NOT under any circumstances, be transformed from Natural
Gas to LPG or vice versa. Any attempt at transformation is hazardous and the Manufacturer
disclaims all liability in the event of any injury to persons or damage to things deriving from this
operation or any other tampering. The appliance must therefore ONLY be assembled by the
Manufacturer and ordered by the user directly for the type of gas to be used to fuel it.

STORAGE

If the appliance is not used for a long time (change of season or other reasons), follow the
instructions below:
- Store the appliance in a dry place, protected against any possible damage.
- ALWAYS cover the burner unit and base to avoid obstructions (cobwebs, dust) or damage
(denting, weather conditions, etc.).
IMPORTANT! NEVER store the appliance together with one or more gas tanks. These must
always be kept in outside premises and in conformity with the Law and Regulations applicable
in the Country of use.
15