Falo 8 kW Gebrauchsanleitung Seite 15

CAREFULLY LOOK AFTER THIS BOOKLET FOR THE ENTIRE LIFE OF THE APPLIANCE
AND REQUEST A NEW ONE IN CASE OF DAMAGE OR LOSS!
IMPORTANT! SHOULD THE PARTS BE DAMAGED, DO NOT GO AHEAD WITH ASSEMBLY!
IMPORTANT! This appliance must be installed in compliance with the Regulations, Laws and
Standards applicable in the Country of use. Installation and use must be in conformity with
the instructions provided by the Manufacturer. Refer to the instructions before installing and
using the appliance.
IMPORTANT! ALL the maintenance, repair or modification operations MUST be performed
by professionally qualified and certified personnel and always using the Manufacturer's
original spare parts.
IMPORTANT! This gas-fuelled appliance is a heat generator intended only for the use for which
it was designed and certified (with room temperature NOT below 0°C for Remote-controlled
mod.), or as an appliance for heating open, ventilated or outdoor environments. All other
uses are to be deemed improper and therefore hazardous. The Manufacturer disclaims all
liability for any injury to persons or animals or damage to things caused by improper use.
IMPORTANT! OPERATION IN CLOSED ENVIRONMENTS IS FORBIDDEN: OFFICES, INSI-
DE HOMES, STABLES, ANIMAL FARMS, PLACES NEAR GAS VAPOURS OR POTENTIAL-
LY INFLAMMABLE DUSTS AND/OR EXPLOSIVES, ETC.
IMPORTANT! Carefully follow ALL the instructions and precautions indicated in this
booklet (concerning INSTALLATION, USE and MAINTENANCE). Failure to abide by these
instructions could cause malfunctions and or endanger people, animal and things.
IMPORTANT! THIS APPLIANCE IS GAS FUELLED AND PARTS OF IT BECOME HEATED.
CONSEQUENTLY, KEEP IT OUT OF REACH OF CHILDREN.
IMPORTANT! NEVER move the appliance with the burner still operating.
IMPORTANT! ALWAYS COMPLY WITH SAFETY DISTANCES FROM OBJECTS OR
INFLAMMABLE MATERIALS(Fig. 2).
IMPORTANT! TO ASSEMBLE AND USE, ABIDE BY THE FIRE-FIGHTING AND ACCIDENT-
PREVENTION REGULATIONS OF THE COUNTRY WHERE THE APPLIANCE IS USED.
IMPORTANT! DO NOT use the appliance set for LPG in basements or cellars.
IMPORTANT! The appliance made to use LPG, CANNOT be fed with or modified to use
natural gas and vice versa.
IMPORTANT! MODIFYING the appliance is absolutely forbidden except ONLY in those cases
indicated and authorised by the Manufacturer.
IMPORTANT! Fit the gas pressure regulator on the cylinder (fixed-setting type) in confor-
mity with the TECHNICAL DATA and GAS SETTING plates on the appliance (Tab. 1 or 2).
IMPORTANT! Every time the cylinder is changed and periodically, using soapy water or
equivalent, make sure there are NO gas leaks from the pipes, from the cylinder connec-
tions, gas distribution connections and gas connection with the appliance. Replace the
seal every time the cylinder is changed and periodically check the state of wear, efficiency,
tube expiry data and all the connections.
IMPORTANT! Before making the connection, make sure the hose connector provided is in
conformity with the Regulations applicable in the Country of use.
IMPORTANT! Before proceeding with assembly operations, make sure all the parts making up
the appliance are suitable for the type of gas and pressures according to the Regulations appli-
cable in the Country of use.
10