Start-Up - Falo 8 kW Gebrauchsanleitung

type and materials required by the Regulations of the Country of use (if those already provided
do NOT conform).
IMPORTANT! MAKE SURE THE SUPPLY PIPE AND GAS CONNECTOR COMPLY WITH
THE STANDARDS REQUIRED BY THE COUNTRY OF USE.
9 – Connect the gas supply pipe to the lower part of the connector (already fitted) (Fig. 7 and 8: 12).
Fitting the battery (for electronic Pilot ignition):
1 – remove the tank cover side panel (Fig. 3: 14) by loosening the screw (Fig. 3: 8);
2 – after locating the battery cylinder (Fig. 4: 1), remove the cover (Fig. 4: 2) and fit the battery
Type AA (Fig .4: 3) respecting the right polarity.
3 – fit everything back correctly in the opposite sequence.

START-UP

IMPORTANT! Remove all the protective films if fitted.
IMPORTANT! Use LPG tanks taking into account the size of the tank compartment (Fig. 3: 13).
IMPORTANT! To prevent any blaze-ups due to gas accumulation, allow 1 or 2 minutes to pass
before repeating the ignition procedure.
NOTE: when first igniting, due to the air in the pipes, the pilot flame tends to go out.
Wait a while before attempting to ignite again (at most 2 or 3 times) until the flame stabi-
lises! If the fault continues, try and identify the cause, see Troubleshooting Section.
- If the pilot should accidentally go out, the incorporated safety device will automatically inter-
rupt the gas supply.
- If the flame goes out for want of gas, the gas flow is interrupted (for example when the gas
cylinder is empty).
- In both cases, you must wait a few minutes before restarting the heater. Then repeat the ope-
rations mentioned in points 1 and 2.
- Do not try to restart the heater time and again; if the heater does not work, you should check
whether ALL operations have been carried out correctly.
IMPORTANT! NEVER start the appliance without first fitting the cover dish and fully completing
assembly. The burner unit and the glass pipe must NEVER be covered or partially covered.
IMPORTANT! DO NOT cover the appliance if this has only just been switched off. Wait for it to
cool down.
IMPORTANT! Protect the appliance against knocks. Always place the appliance on fairly flat
surfaces to prevent it overturning (gradient < 10°) and on non-inflammable surfaces (wood, lino-
leum, synthetic floors, etc).
IMPORTANT! The appliance is equipped with a safety device (Fig. 16) that extinguishes the
flame in case of surface with slope greater than 15°.
IMPORTANT! WHEN FIRST STARTED – IN THE OPEN AIR OR WELL-VENTILATED ENVIRON-
MENT – THE APPLIANCE COULD GIVE OFF VAPOURS OR SMELLS FOR A SHORT TIME.
Ignition – MANUAL mod.
Regulation sequence, turn knob: OFF, spark ON, MIN and MAX;
1 – Make sure the ignition/regulation knob (Fig. 3: 10) is in OFF position (Fig. 5: 1) and open
the gas supply tap.
2 – Push and turn the ignition/regulation knob (Fig. 5) anticlockwise. The spark discharge and
gas opening for pilot ignition will start automatically.
Once the flame has ignited, continue to press the knob for about 15 seconds to allow the ther-
13