General Description - Falo 8 kW Gebrauchsanleitung

GENERAL DESCRIPTION

Due to its specific type of operation with direct and reflected irradiance, this appliance approxi-
mately heat up a surface of 13 m
cific region could influence the device efficiency, as the appliance position (totally or in part
open space) as your subjective heating feelings. The heating feeling substaintially increases
close to the appliance.
The appliance is very simple to use and built according to CE safety standards. It has been
tested, approved and controlled by the Notified Approval Institute to which the Manufacturer has
always entrusted most of its certifications in the gas industry.
Types of installation:
- MOBILE, with the base free of restraints using the trolley (optional), with LPG fuel only (tank).
- FIXED, with the base fastened to the floor (this type of installation must be carried out only by
professionally skilled personnel), using Propane/Butane gas (large tank) or natural mains gas.
ASSEMBLY
Take all the parts making up the appliance out of the packaging, with special care given to the
burner unit (Fig. 3: 3, 4, 7, 9, 10).
Check the integrity and the conformity of the contents of the packaging (the latter must be
disposed of according to applicable regulations):
A - Mod. FALO' with manual controls
- Appliance with carrying structure and special-glass pipe;
- Hose connection (make sure this complies with applicable regulations);
- Cover dish;
- Multilingual instruction booklet;
- Warranty Certificate.
B - Mod. FALO' with Remote Control
- Appliance with carrying structure and special-glass pipe;
- Hose connection (make sure this complies with applicable regulations);
- Cover dish;
- Multilingual instruction booklet;
- Warranty Certificate.
IMPORTANT! Always wear individual hand protection gear during appliance assembly and
positioning. Use the special accessory for moving (Fig. 3:18) to prevent cuts and burns.
ASSEMBLY OPERATIONS (MOBILE type with LPG tank):
Before starting assembly operations, remove any guards.
1 – Delicately place the structure on the ground and fit the cover dish (Fig. 3: 2).
2 – Remove the side panels (Fig. 3: 14, 15) and position the tank on the base plate (Fig. 3: 13).
3 – Fit the gas pressure regulator on the cylinder (fixed-setting type) in conformity with
the TECHNICAL DATA and GAS SETTING plates on the appliance (Tab. 1 or 2).
4 – Purchase the connector and the rubber connection hose separately. These must be of the type
and materials required by the Regulations of the Country of use (if those already provided do NOT
conform).
with a range of action of 2 meters. The weather of your spe-
2
11