Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
2. FIRST POWER-UP
PACKAGE CONTENTS
On opening the IA504R amplifier package, check that no items are missing. The package contains:
•
power cable
•
IA504R amplifier
•
5x female Euroblock connectors (2x 6 poles 3.81mm pitch connectors, 1x 8 poles 3.81mm pitch connector and
2x 4 poles 5.08mm pitch connectors)
•
quick start manual and warranty documentation
SIGNAL PROCESSING
The signal processing is managed by the AURORA NET software; it is divided into the following sections from the
audio source input to the speaker outputs: Input Section, Processing Channels and Output Section.
You can use the Input Section to set the input gain, delay and eq for the signals from the four analogue inputs;
the input matrix (Input Selection) sends the signals to one or more processing channels. Delay, equalisation and
compression can be applied to them. The output matrix accepts both pre- and post-processing channels and sends
them to the power outputs. You can load presets created specially by dBTechnologies for its own passive speakers.
For further details, read the AURORA NET section in this manual.
3. AURORA NET
The AURORA NET software can be used to display and control all the parameters of the IA504R amplifier. Below
there is an overview of the controls available when you load an instance of IA504R into your project on AURORA
NET (Amplifiers section).
IA504R
Cod. 420120398 REV. 1.0
35
Werbung
Inhaltsverzeichnis
Fehlerbehebung
