Power Supply Section - dB Technologies IA504R Bedienungsanleitung

8
10
8. ANALOGUE AUDIO INPUTS
Analogue audio inputs on 3.81mm Euroblock connectors.
9. CONTROLS
Connections in 3.81mm Euroblock format, which can be used as GPI, GPO, analogue and as a dedicated standby
input. For further details, read the GPIO chapter in this manual.
10. RDNET PORT
Connection in RJ45 format to control the amplifier via an RDNet Control 2 or RDNet Control 8 hardware interface.
11. POWER OUTPUT
Power output on a 5.08mm Euroblock connector. It can be used with an impedance of 4, 8 or 16 Ohm in single-
channel mode, or 8 or 16 Ohm in bridge mode, and can drive 100V or 70V systems. dBTechnologies has created
presets for its own passive speakers, which can be downloaded via the AURORA NET software for an optimal
listening experience.

POWER SUPPLY SECTION

12. POWER SOCKET
For use with the power cable provided. The power supply is of the full range type.
ATTENZIONE
• Do not obstruct the amplifier cooling fins at the back. In the event of overheating, the
audio volume is gradually reduced until the module is thermally stable. The level is
automatically restored on reaching the correct operating temperature.
• In the event of malfunction, immediately turn off the power and disconnect the module
from the mains. Contact an authorised service centre.
• Do not attempt to open the amplifier.
• Periodically check the connection cables to ensure they are in good condition.
IA540R
34
9
!
11
English
12
Cod. 420120398 REV. 1.0