Blaupunkt ADH601 Bedienungsanleitung Seite 9

ADH601
TECHNICAL SPECIFICATIONS
Rated power(EN60335): 260 W (30°C, 80%)
Maximum current: 1,3 A (30 , 80%)
Moisture removal (30 , 80%) 16 liters/day °C
Voltage: 220-240 V ~50 Hz
Tank volume: 5 L 2,
Air-flow rate 130 m³ /h
Refrigerant: R290/0,065 Kg
Maximum noise level: 47 dB ≤
Permissible excessive operating pressure for suction: 1,0 Mpa
Permissible excessive operating pressure for discharge: 2,6 Mpa
Maximum allowable pressure: 4,0 Mpa
WiFi transmitter frequency range: 2.400 to 2.484 GHz
WiFi transmitter power: ≤17.5 dBm
CONTROL PANEL DESCRIPTION
1. LED Display
2. Control panel lock button
3. TIMER button – operating time setting
4. SPEED button – changing fan output
(WiFi reset)
5. HUM button – setting humidity level
6. MODE button – operating mode settings
7. POWER button – on/off switch
DEVICE OPERATION
The dehumidifier has three operating modes: laundry drying mode, dehumidification mode,
continuous dehumidification mode. To start the device, press the "POWER" button. Each press of the
"MODE" button switches the operating mode to the next one.
Laundry drying mode: maximum output and maximum blowing level. Neither the humidity nor fan
speed can be set.
Dehumidification mode: The humidity and fan speed can be set. The device will turn on and off while
keeping the humidity in the room below the value chosen by the user.
Continuous dehumidification mode: The device will operate in continuous mode. The humidity cannot
be set, the fan speed can be set.
Humidity setting:
The humidity level can be set between 30% RH and 80% RH in 5% increments. Each press of the "HUM"
button increases the expected humidity level by 5%. After 5 seconds after selecting the expected
humidity level, the display will indicate the reading of the humidity sensor. When the humidity is
above or below the set humidity value, the dehumidifier automatically turns on or off. When the
humidity level is set to 30% RH, the dehumidifier will operate in the continuous dehumidification
mode.
The LED at the "HUM" button indicates the compressor status.
Setting the timer:
The dehumidifier has a delayed start and shutdown function. To set the time for delayed start or
shutdown, press the "TIMER" button. Each press will increase the time by 1 hour. Pressing the button
longer will change the time more quickly. You can set the timer up to 24 hours. If the delayed start/off
function is active, the LED at the TIMER button will be lit.
"CHILD LOCK" – control panel lock
To lock the control panel, hold down the "CHILD LOCK" button for 2 seconds, the control panel and
other buttons will be locked. To unlock the control panel and buttons, press and hold down the "CHILD
LOCK" button again for 2 seconds.
°C
(A)
8. Full tank LED
9. Control panel
10. Air exhaust
11. Handles
12. Air inlet
13. Water drain
14. Water container
15. Water discharge hose
7