Blaupunkt ADH601 Bedienungsanleitung Seite 20

ADH601
BESCHREIBUNG DES BEDIENFELDS
1. LED - Anzeige
2. Verriegelungsknopf des Bedienfelds
3. Taste TIMER - Einstellung der
Arbeitszeit
4. Taste SPEED - Änderung der
Lüfterbelüftungskraft (WLAN-Reset)
5. Taste HUM - Einstellung der
Luftfeuchtigkeit
6. Taste MODE - Einstellung der
Betriebsart
DEVICE OPERATION
The dehumidifier has three operating modes: laundry drying mode, dehumidification mode,
continuous dehumidification mode. To start the device, press the "POWER" button. Each press of the
"MODE" button switches the operating mode to the next one.
Laundry drying mode: maximum output and maximum blowing level. Neither the humidity nor fan
speed can be set.
Dehumidification mode: The humidity and fan speed can be set. The device will turn on and off while
keeping the humidity in the room below the value chosen by the user.
Continuous dehumidification mode: The device will operate in continuous mode. The humidity cannot
be set, the fan speed can be set.
Humidity setting:
The humidity level can be set between 30% RH and 80% RH in 5% increments. Each press of the "HUM"
button increases the expected humidity level by 5%. After 5 seconds after selecting the expected
humidity level, the display will indicate the reading of the humidity sensor. When the humidity is
above or below the set humidity value, the dehumidifier automatically turns on or off. When the
humidity level is set to 30% RH, the dehumidifier will operate in the continuous dehumidification
mode.
The LED at the "HUM" button indicates the compressor status.
Setting the timer:
The dehumidifier has a delayed start and shutdown function. To set the time for delayed start or
shutdown, press the "TIMER" button. Each press will increase the time by 1 hour. Pressing the button
longer will change the time more quickly. You can set the timer up to 24 hours. If the delayed start/off
function is active, the LED at the TIMER button will be lit.
"CHILD LOCK" – control panel lock
To lock the control panel, hold down the "CHILD LOCK" button for 2 seconds, the control panel and
other buttons will be locked. To unlock the control panel and buttons, press and hold down the "CHILD
LOCK" button again for 2 seconds.
Memory function:
The device automatically restores the operating status when the power is turned on. If the device is
turned on and there is a power outage when the voltage returns, the device will start while
maintaining the configured parameters or pre-off settings.
Automatic defrosting function:
When the internal temperature on the cold plate reaches a temperature close to zero, the dehumidifier
will automatically start the defrosting mode. The unit will be turned off, the fan will work at full speed.
The "DEHU" LED on the control panel will flash. The dehumidifier will resume operation once the right
temperature is reached.
Overflow protection:
When the tank is full of water, the device will turn off automatically. The indicator will flash and the
7. Taste POWER - Schalter
8. Kontrollleuchte "Volltank"
9. Bedienfeld
10. Luftauslass
11. Griffe
12. Lufteinlass
13. Wasserablauf
14. Wassertank:
15 Entwässerungsschlauch
18