Blaupunkt ADH601 Bedienungsanleitung Seite 10

ADH601
Memory function:
The device automatically restores the operating status when the power is turned on. If the device is
turned on and there is a power outage when the voltage returns, the device will start while
maintaining the configured parameters or pre-off settings.
Automatic defrosting function:
When the internal temperature on the cold plate reaches a temperature close to zero, the dehumidifier
will automatically start the defrosting mode. The unit will be turned off, the fan will work at full speed.
The "DEHU" LED on the control panel will flash. The dehumidifier will resume operation once the right
temperature is reached.
Overflow protection:
When the tank is full of water, the device will turn off automatically. The indicator will flash and the
device will give an audible signal. After draining the water from the tank, the indicator will go out and
the dehumidifier will restart. Note: The water tank must be in the correct position.
Continuous drainage function:
To allow continuous drainage of water, with the water tank bypassed, the continuous hose must be
connected
for drainage (15) in the water drain (12), and the other end of it put in the drain into the sewer.
RESETTING THE APPLIANCE SETTINGS AND ESTABLISHING A NEW CONNECTION
To connect the device to the local WiFi network, reset the WiFi connection settings. The device should
be in sleep mode. Press the "SPEED" buttons and hold for about 5 seconds. When the WiFi LED will flash
quickly, the appliance will be ready to search. CAUTION: the appliance operates only with 2.4 GHz
wireless networks. The network should use WPA2-PSK encryption and AES protocol.
CONNECTING THE APPLICATION WITH THE APPLIANCE USING WIFI AND BLUETOOTH
Press the "add device" button after starting the application. The appliance should be found after about
15 seconds. Press the button to continue adding. Select the available WiFi network and enter the
appropriate password. Press the button to continue. After a while, a message indicating that the
appliance has been added correctly should be displayed.
CONNECTING THE APPLICATION WITH THE APPLIANCE USING WIFI
Press the "add device" button after starting the application. In the "Add manually" section, select the
product group "small appliances..." and then the "air dehumidifier". Then select the available WiFi
network and enter the appropriate password. The application should disconnect from the current WiFi
network, connect with the appliance and provide configuration parameters. The application should
return to the previous network. After a while, a message indicating that the appliance has been added
correctly should be displayed.
CONTROLLING THE APPLIANCE USING THE APP
The application indicates the current temperature and humidity in the room.
The application allows you to change the expected humidity level, choose the intensity of air supply,
8