Cleaning, Care & Maintenance - Polar CP728 Bedienungsanleitung

Cleaning, Care & Maintenance
Take out all food in the cabinets and disconnect the appliance from the electricity.
•
• Wait until the traces of ice on the evaporator have melted, then wipe inside to remove any water.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
Condensation will form in refrigeration with frequent opening of the doors and on hot humid
days, please ensure condensation is allowed to drain properly or is wiped dry.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is not
working
Poor refrigeration
performance
Showcase is noisy
when turned on
Error code EE4
CP728_ML_A5_v4_20221027.indb 5 CP728_ML_A5_v4_20221027.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
High ambient temperature
Poor ventilation
Door seals not in place/worn
Too much food in the Showcase is
preventing cold air circulating
Condenser needs to be cleaned
Showcase is not level
Showcase is too close to a wall or
other object
• Restricted Airflow
• Blocked Condenser
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the fuse
Check mains power supply
Ventilate room or area around Showcase
Increase air flow around Showcase
Replace door seals
Take out some food
Clean Condenser
Adjust position to level
Move position
• Increase airflow
• Consult a qualified Technician
EN
5
2022/10/27 10:03 2022/10/27 10:03