Cleaning, Care & Maintenance - Polar CC611 Bedienungsanleitung

Should the parameter need adjusting:
1. Press and hold the SET button for six seconds. The "E1" parameter is displayed
2. Press the or buttons until the required value is displayed
3. Press the SET button to store the new value and cycle to the next parameter
NOTE: The controller times out after 10 seconds if no buttons are pressed
Manual Defrost:
Press and hold the button for 6 seconds to begin automatic defrost. The defrost light illuminates
Storing Food
To get the best results from your POLAR appliance, follow these instructions:
• Only store foodstuffs in the appliance when it has reached the correct operating temperature.
• Do not place uncovered hot food or liquid inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans/vents inside the appliance.
• Avoid opening the doors for prolonged periods of time.
Cleaning, Care & Maintenance
• Switch off and disconnect from the power supply before cleaning.
• The doors can be removed for ease of cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• Do not allow water used in cleaning to run through the drain hole into the evaporation pan.
• A POLAR agent or qualified technician must carry out repairs if required.
Replacing the Interior Lamp
WARNING: Allow the lamp to cool before replacing. The lamp remains hot
immediately after use.
1. Turn Off and disconnect the appliance from the mains power supply.
2. Remove the lamp by twisting it from the lamp sockets.
3. Insert the new lamp and twist into place.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance.
POLAR recommend that a POLAR agent or qualified technician clean the condenser.
CC611-CC666_ML_A5_v6_20180125.indb 5
UK
5
2018/1/25 17:31