Operation; Cleaning, Care & Maintenance; Auto Defrost - Polar CS586 Bedienungsanleitung

UK

Operation

Control Panel
The control panel is located at the front of the
cabinet.
Turn On
1. Turn the thermostat to the desired temperature
setting:
I (cool) to IV (Cold)
Note: Setting the switch to '0'
turns off the appliance.
2. Close the door of the appliance.
3. Connect the appliance to a mains power supply.
Cleaning, Care & Maintenance
Switch off and disconnect from the power supply before cleaning.
• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seal with warm soapy water.
• Always wipe dry after cleaning.
• A POLAR agent or qualified technician must carry out repairs if required.
• If left unused for any length of time, store the appliance with the door ajar.

Auto Defrost

Periodically the appliance will run an automatic defrost cycle to prevent any ice build-up.
Cleaning the Condenser
Periodic cleaning of the Condenser can extend the life of the appliance. POLAR recommend that a POLAR
agent or qualified technician clean the condenser.
6
CS586_ML_A5_v2_20200402.indb 6 2020/4/2 09:59