Other Faults - Haier XIB 6B2D3FB Bedienungsanleitung

ONLY MODELS WITHOUT A DISPLAY
If malfunctions or faults occur when a programme is running, the indicator light that corresponds to the
selected cycle will blink rapidly, and an intermittent audio signal will sound. In this case, turn the
dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water supply is open, that the drain pipe is not bent and that the
siphon or filters are not clogged, set the selected program again.
If the fault persists, contact the Technical Assistance Centre.
This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically
discharges any excess water.
WARNING
To ensure the correct operation of the overflow safety device, we recommend not moving or
tilting the dishwasher during operation. Should it be necessary to tilt or move the dishwasher,
please ensure that the washing cycle is complete and that no water remains inside the appliance.

OTHER FAULTS

FAULTS
1. No programme
works
2. Dishwasher does
not fill with water
3. Dishwasher does
not discharge water
4. Dishwasher
discharges water
continuously
5. Spray arms are not
heard to rotate
CAUSE
Plug not connected to wall socket
O/I button not pressed
Door is open
No electricity
See point 1
The water tap is closed
The water supply hose is bent
The filter of the water supply hose is
clogged
Filter is dirty
Drain pipe is bent
The drain pipe extension is not
correctly connected
The outlet connection on the wall is
pointing downwards not upwards
Position of the drain pipe is too low
Excessive amount of detergent
Item prevents arms from rotating
Filtering plate and filter very dirty
EN 114
SOLUTION
Connect electric plug
Press button
Close door
Check
Check
Open the water tap
Eliminate the bends in the hose
Clean the filter at the end of the hose
Clean filter
Eliminate the bends in the pipe
Follow the instructions for connecting the
drain pipe carefully
Call a qualified technician
Lift drain pipe to at least 40 cm above
floor level
Reduce amount of detergent Use
suitable detergent
Check
Clean filtering plate and filter