Problem Solution; Environmental Protection - Worx WX394.91 Originalbetriebsanleitung

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
SECURE WORKPIECE
A workpiece clamped with clamping devices is held
more secure than by hand.
INTENDED USE
The machine is intended for hammer drilling in
concrete, brick and stone. It is also suitable for
drilling without impact in wood, metal, ceramic and
plastic.
OPERATION
ACTION
Removing The Battery
Inserting The Battery
Selecting The Operating Mode
HAMMER DRILLING
Inserting Drill Bits
Removing Drill Bits
DRILLING & SCREWDRIVING
12
Inserting Drill Chuck
Inserting Bits into Chuck
Removing Drill Chuck
Removing Bits from Chuck
On/Off Switch
Switch Lock
NOTE: The Switch Trigger Can Be
Locked In The Off Position.
Forward Rotation Control
Reverse Rotation Control
LED Light
Temperature Dependent
Overload Protection
Protection Against Deep
Discharging
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes
to cool the motor. SDS-plus tungsten carbide
Cordless Rotary Hammer
drill bits should always be used for concrete and
masonry.
When drilling in metal, only use HSS drill bits in
good condition. Where possible use a pilot hole
before drilling a large diameter hole.

PROBLEM SOLUTION

1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, having not used a battery
pack for a prolonged time will reduce the battery
pack working time. This can be corrected after
several charge and discharge operations by charging
& working with your tool. Heavy working conditions
such as large screws into hard wood will use up
the battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack below
FIGURE o
0 C and above 30
See Fig. A1
MAINTENANCE
See Fig. A2
Remove the battery pack from the tool before
See Fig. B
carrying out any adjustment, servicing or
maintenance.
Never use water or chemical cleaners to clean your
See Fig. C1
power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
See Fig. C2
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
See Fig. D1
damage your power tool.
See Fig. D2
ENVIRONMENTAL
See Fig. D3
PROTECTION
See Fig. D4
See Fig. E
See Fig. F
See Fig. G
See Fig. H
See Fig. I
/
/
o
C as this will affect performance.
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling advice.
EN