Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CARE AND CLEANING
WARNING! For safety's sake, be sure to turn the air conditioner
OFF and also disconnect it from the power supply before cleaning
it.
1. Cleaning of the Air Filters.
The air filters must be checked at least once every two weeks
operation. Operation with a dirty filter always causes a lower
efficiency of the air conditioner and severe product damage.The
filters are located behind the left and right intake grilles and can
be removed from the rear side of the unit. Use a vacuum clean-
er to remove light dust. If there is sticky dust on the filter, wash
it with lukewarm soapy water, then rinse in clean, cold water
and dry it before reinstallation.
2. Cleaning of Casing and Grille.
To clean the air conditioner, wipe it with a clean soft cloth, light-
ly moisted. In case it is stained, moisten the cloth with soapy
water. Never use solvents or harsh chemicals, nor very hot
water. Do not pour water over the air conditioner to clean it: this
will damage the internal components and cause an electric
shock hazard.
3. Storage.
If you are not going to make use of the air conditioner for a long
period, before storing it away clean the air filter and verify that
both the internal water tanks are empty. Always store the unit in
the vertical position. Do not put heavy objects on top of the unit
and protect it with a cloth or a plastic bag.
4. Transport.
Preferably keep the air conditioner in the vertical position during
transportation. If this is not possible, then lay it on one side;
when at destination put the air conditioner back in the vertical
position and wait at least 10 minutes before using it for cooling.
5. For your safety care check periodically the conditions of
the electric supply cable; the electrical connection of the
unit is X type with cable prepared in a special way; in case
you should notice any damage due to usage, call the near-
est After Sale Service to get the cable replaced.
USEFUL ADVICE
If your air conditioner doesn't work properly, before requesting service, verify that:
G
the plug is properly inserted into the power socket;
G
the circuit breaker is in the ON position and fuses have not blown;
G
the air filter is not clogged;
G
the flexible tube is correctly positioned without any sharp bends nor plies;
G
the thermostat knob is in the proper position for the suitable temperature (twisting it clockwise verify the compressor re-
start, after the delayed time);
G
the room temperature is above 15°C for cooling mode and 10°C for dehumidification mode;
G
you have correctly carried-out the instructions contained in this manual.
ATTENTION
The blinking of lamp (H), together with the stop of the air conditioner indicate that the condensate water tank is full.
All manuals and user guides at all-guides.com
NO!
Filter
FILTER CLEANING
NO!
Filter
EG
6
Werbung
Inhaltsverzeichnis
