Medisana 92721 Gebrauchsanweisung Seite 24

88386_BBS_WEST_HOW.qxd:Luftsprudelbad
GB
2 Operation
16
05.01.2012
Adjustments on the pump unit
Spa intensity
• Press the power button
in the lowest mode (Low) immediately. The Low LED lights up green.
• Press the power button
appliance now operates in the medium mode (Medium).
• Press the power button
The appliance now operates in the highest mode (Hi).
• Press the power button
The appliance now operates in the automatic interval massage program
(Program). The appliance runs through the three levels of intensity in succession
(Low, Medium, High) and then back to the beginning.
• The next time you press the power button
Preset operation time
The timer button allows you to choose between three time settings: 30, 20
or 10 minutes. It is not advisable to use the appliance for more than 30 minutes
(see safety instructions). Leave an interval of at least 30 minutes before you switch
on the appliance again.
• Press the timer button
10 LED starts flashing yellow.
• Press the timer button
The 20 LED starts flashing yellow.
• Press the timer button
The 30 LED starts flashing yellow.
Once the preset time has elapsed, the appliance switches off automatically. If no
time has been set, the appliance switches off after 10 minutes.
Switching on the heat function
NOTE
The heat function is not designed for the water temperature or
for heating up a cold bath. Warming the air created by the spa
bubbles, prevents the bath water from cooling down while it is
in use.
If you want to use the heat function, press the heat button
it lights up red. Press the heat button
the LED light disappears.
Adjustments on the remote control
• If you want to use the infrared mode
switch on the appliance by pressing the power button
trol.
15:57 Uhr
once. The appliance switches on and starts operating
again. Now the Medium LED lights up green. The
a third time. Now the High LED lights up green.
a fourth time. Now the Program LED lights up green.
, the appliance switches off again.
once. The operation time is set for 10 minutes. The
once again. The operation time is set for 20 minutes.
a third time. The operation time is set for 30 minutes.
again to switch off the heat function and
, firstly get into the bath carefully and
Seite 16
. The LED next to
on the remote con-