Inhaltsverzeichnis
Werbung
Battery Power Measurement
The battery capacity is full, the battery power is high
. When the battery displays 1 grid, the device is in
low battery mode and makes a low battery warning in the form of the prompt.
Note:
Take out the battery from the radio to save it. The battery may become corrosion by the time and do the forever
damage to your device.
-Don't mix the old/new/alkaline/ NI-MH batteries together to use.
-Charge the provided NI-MH battery every 3 months when not using the radio.
Turn ON/OFF the Device
After installing the batteries, the device is turned on and has a prompt. LCD display will briefly display all
function icons, then it will display the available channel and CTCSS/DCS. Press the Power key, the radio is
turned off.
Set Volume
-Press UP key to increase the volume.
-Press the DOWN key to decrease the volume.
-The magnitude of the volume is indicated by the displayed number 1-16.
Set Channel
1.Shortly press the Menu key and the current channel flashes.
2.Press the UP key or DOWN key to choose channel number.
3.Press the PTT key to confirm and save channel settings.
Communication
When communicating, all the devices of the group set the same channel number and CTCSS/DCS code; When
you start to communicate, please keep 2-3inch between the device and the mouth. Press the PTT key to talk.
When you finish talking, release the PTT key. (Press the key to transmit, release the key to receive).
Featured Function
CTCSS/DCS Code
The distribution of the CTCSS/DCS code can decrease the interference between radios, but radios can't
communicate with each other with different CTCSS/DCS codes. To ensure your private communication, each
channel has 0-121 CTCSS/DCS codes to be set.
1.Shortly press the NENU/Power key twice or until the CTCSS/DCS code starts to flash.
2.Press the UP key or DOWN key to choose code 0-121 or 121-0.
3.Press the PTT key to save code settings.
You can use the procedure to set different CTCSS/DCS codes for each channel.
Note: if you want to communicate with the other device without setting CTCSS/DCS codes, you must set your
CTCSS/DCS code to 0.
TOT
To prevent accidental transmission or occupying channel for a long time, if you press the PTT key to
continuously transmit for 60s, the device will make a continuous warning tone and stop transmitting.
Key Lock
To prevent accidentally changing the setting of the radio, press the CALL/Key Lock for 3s or until the key lock
icon is displayed. At this time, you can turn on/off the radio, adjust the volume, receive, transmit, transmit call
03
Werbung
Inhaltsverzeichnis
