Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
You can also start frying in both fryers sequentially - first set the frying parameters for the first fryer and
start the preparation with the power button. Then press button 2 and repeat the procedure for the second
fryer.
•
While both fryers are frying, you can press the temperature/time switching button to briefly display the
frying temperature setting on the corresponding display for the fryer. After 3 seconds, the displays will
again show the remaining preparation time.
Changing the frying parameters
•
If you need to change the temperature or time while using both fryers at the same time, first press
the button to select the appropriate fryer and then adjust the temperature and time as required. The
programme cannot be changed during preparation. If you do not perform any operation within 10
seconds, the screen will automatically return to normal mode.
•
If you need to change the cooking program during frying, you must first pause the frying by pressing the
1/2 button and the power button. You can then change the programme. Press the power button again to
start frying again.
•
If you do not take any action for 5 minutes after pausing the cooking process, the fryer will go into standby
mode.
Switching off one fryer
•
Press the fryer button 1 or 2 and then long press the power button. The selected fryer goes into standby
mode.
Pulling out the frying pan
•
If you pull out the frying pan during cooking, the display will show "OPEN". The frying in the frying pan will
stop and will not continue until you put the pan back in. The second fryer will continue to cook without
interruption. You can remove one frying pan at any time and work with the food without affecting the
preparation in the other fryer.
•
If you pull out the fryer in standby mode, the display will show "OPEN". At this point, the fryer cannot be
used.
Pause frying
•
If you press the power button while frying in both fryers, the frying process will be paused. Both displays
and program indicators will flash. If you press the power button again, frying will continue.
•
If you pause the frying and do not perform any operation within 5 minutes, both fryers will go into standby
mode.
•
Once you have paused the frying, you can change the preset programme, temperature and time as
required by pressing the appropriate button of the left (1) or right (2) fryer. After changing the settings,
you can continue frying by pressing the power button.
Stop preparation in both fryers
•
If you press and hold the power button for at least 2 seconds during frying, frying will be interrupted and
the "OFF" message will be displayed on both displays. The appliance beeps briefly and enters standby
mode.
If you want to stop cooking in only one fryer, first press button 1 or 2 to select the appropriate fryer and
•
then press and hold the power button for at least 2 seconds. Frying in the selected fryer will be interrupted
and the display will show "OFF". The appliance beeps briefly and the fryer goes into standby mode. At this
point, the fryer's operating mode changes to frying in one fryer only.
Concurrent end of preparation
•
This function is only active if you set both fryers to fry, but a different program is set for each fryer with a
different duration. In this case, the simultaneous stop button lights up.
•
If the button is pressed before frying begins, the food in both fryers will be adjusted so that the frying is
finished at the same time. Thus, if one pot is set to a shorter time than the other, the frying in that pot will
start later so that the preparation in both fryers is completed simultaneously.
•
During the delayed start of cooking, the display of the fryer with the shorter time will show "HOLD".
11
Werbung
Inhaltsverzeichnis
