Cointra L5 Handbuch Seite 9

5. Attach shower nozzle to the fitting marked "Water
Outlet" (middle connection). Connect using hand
pressure ONLY. If installing in an existing water system,
connect the hot water line directly to the ½" NPT/BSP
fitting.
6. Install two "D" cell batteries in the compartment on the
bottom left of the heater. Check that batteries are facing
the correct direction.
7. Use the top tab on the unit to suspend from a screw
adequate to holding 15 pounds/6.8 KG. Place at a
comfortable height without putting stress on the gas
hose. If the unit is to be permanently mounted, use
screws to attach the bottom tab firmly. DO NOT USE
SUSPENDED FROM THE HANDLE!
8. Attach gas regulator with hose to the LP tank. Use hand
pressure only on the plastic connector. LEAVE GAS TANK
VALVE IN THE "OFF" POSITION"
7