Getting Started - Cointra L5 Handbuch

Getting Started

1. Check box for damage. Damages caused in shipment
must be reported immediately
2. Make sure you have all the parts:
a. Heater Body and Bottom Wind Shield
b. Gas Regulator and Shower Nozzle/Hose Set
c. Hardware Pack and quick disconnect adapters
3. For North American use, if using a standard garden hose,
attach the ½" NPT to garden hose adapter to the fitting
marked with a blue arrow (far right ½" connection). For
European models, simply attach your water source hose
to the far right connection. Use "Teflon" tape or other
approved sealing method on the threads for a secure,
water tight fit. Check to make sure the screen inside the
water inlet is in place and clean and then attach your
water input/garden hose.
4. Install gas supply line and regulator to the water heaters'
compression fitting (North American models). DO NOT
OVER TIGHTEN. OVER TIGHTING MAY CRACK THE GAS
REGULATOR CAUSING A GAS LEAK! Check for any gas
smell before ignition! Make sure it is screwed all the way
on. EUROPEAN MODELS, ensure that the black rubber
washer is installed inside of the gas connection line.
6