Cointra L5 Handbuch Seite 17

there could be a cracked gas regulator. Do Not Attempt to use the
unit and call Eccotemp directly.
Water is flowing, but there is no hot water coming out:
a. Ensure that you have the incoming water supply and the
outgoing water supply hooked up properly. Your water supply
should be attached to your incoming connection (located on the
far right) and the shower head should be attached to the
outgoing water (located as the center connection)
b. Ensure that you have adequate water pressure of at least 20
PSI / 1.38 bar, sustained.
c. Ensure that you have adequate gas in your propane bottle and
that the LP regulator is threaded all of the way on to the unit.
d. Fresh batteries are required for ignition spark. Make sure
batteries are aligned in the proper polarity (+/-)
If you are still having troubles or are on a modified water system,
please call technical support found on page 1.
The unit does nothing:
a. Ensure that you have your water source hooked up to the
water inlet side (far right connection) and the shower handle is
hooked up on the water outlet side (far right connection)
b. Ensure that you have an adequate supply of propane
c. Ensure that you have fresh batteries
If you are still having troubles or are on a modified water system,
please call technical support at found on page 1
15