Handling And Positioning - Gastrodomus GA700CTN Bedienungsanleitung

- Protect from sunlight;
- Avoid impacts;
- If stored for a prolonged period of time (more than three months), regularly check the condition of all
the packaging.
4.3 Disposal
At the end of the appliance's working life it must be disposed of in accordance with the current local and
national regulations.
The appliance contains electrical and electronic components, referred to as "Waste of electrical and electronic
equipment" (WEEE).
In accordance with Italian Legislative Decree 49/2014, which implements Directive 2012/19/EU, the
Manufacturer requires that the appliance be disposed of at authorised collection centres, to avoid potential
affects on the environment and to protect human health.
The symbol shown alongside indicates the need to dispose of the appliance according
to the WEEE requirements when it is scrapped.
To avoid any unauthorised use and the related risks, ensure that the appliance cannot be reactivated before
disposing of it. To do this, the appliance must be disconnected from the power supply and the power supply
cable must be cut.
5. Installation and operation of appliance
5.1 Electrical connection (plug-socket)
All models have a power supply cable with a Schuko plug.
The appliance must only be connected to an electrical socket that is individually protected against indirect
contacts in compliance with the regulations in force in the country of use. Do not remove the appliance's plug
by pulling the power supply cable.
The power supply cable must never be placed in contact with hot objects.
Do not spray water on the appliance and do not expose it to rain, water or any other source of humidity.
The appliance can cause injuries if it is not installed correctly. Before installing the appliance compare the
parameters of the local electricity mains supply with the technical data of the appliance (see the identification
plate on the rear of the appliance, Pic.2 - Section 8). Only connect the appliance to the mains if the above-
mentioned data correspond! All the safety instructions must be complied with!
- Ensure that the power supply cable does not come into contact with heat sources or sharp edges and
that it does not become blocked under the appliance. Ensure that the cable is laid out properly, and not rolled
up or bent;
- The power supply cable must not be laid on carpets, tablecloths, mats or on other heat insulating
materials, nor covered or immersed in water or other liquids and it must be positioned where it cannot be
walked on;
- Position the appliance so that the plug is always accessible;
- Do not use extension cords, adapters or reducers.

5.2 Handling and positioning

Ensure that, from the point of view of the overall dimensions (see Table 1 - Section 9), the space provided for
the appliance allows its correct use and easy servicing as indicated in subsection 6.
- Remove the appliance from the packaging, be sure to follow the instructions in Section 4 (Environmental
notes) with regard to the storage and disposal of the packaging materials;
- While always keeping the appliance level, move and position it on a stable and correctly levelled surface (the
height of the legs can be adjusted to compensate for any uneven surfaces).
18