Siemens TI9573X1RW Gebrauchsanleitung Seite 41

Problem
The coffee grounds are not
compact and are too wet.
Water dripped onto the inner
floor of the appliance when the
drip tray was removed.
The drip tray cannot be
removed.
The outlet system cannot be
assembled or disassembled.
Display shows "Fill bean con-
tainer". Displayed although the
bean container )B is already
full, or the grinder is not grind-
ing any coffee beans.
Display shows: "Empty drip
tray" even if the drip tray is
empty - what to do?
Display shows "Refill with still
water" or "Remove filter"
Cause
The grinding level is set too fine
or too coarse, or not enough
ground coffee has been used.
Drip tray removed too early.
The coffee grounds container is
very full.
The coffee grounds slider is
stuck.
Incorrect sequence
Beans are not falling into the
grinding unit (beans too oily).
Emptying is not detected when
the appliance is switched off.
The drip tray is soiled.
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Trouble shooting en
Solution
Set a coarser or finer grinding level or
use 2 level measuring spoons of
ground coffee.
Wait a few seconds after the last drink
was dispensed before removing the
drip tray.
Clean the interior of the brewing unit.
~ "Cleaning the appliance"
on page 34
Correctly insert the coffee grounds
slider.
Connect the outlet system (with milk
system) first, then connect the milk
container. Alternatively, on disassem-
bly first remove the milk container and
then the outlet system.
Gently tap the bean container.Possibly
change the type of coffee. When the
bean container is empty, wipe it with a
dry cloth.
When the appliance is switched on,
remove and re-insert the drip tray.
Clean the drip tray thoroughly.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter in water until
no more air bubbles escape, then
insert the filter again.
Insert a new water filter.
41