Herunterladen Inhalt Inhalt Diese Seite drucken

Choice Of Flue Gas And Air Connection Placement - Wamsler SOSA Aufstellanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

things, arches must have inspection openings for the chimney sweep and be properly
insulated against condensation. The line should not be longer than 4 m and not have
more than 3 bends. If the line leads outdoors, it should be provided with a suitable
windbreak and fly screen.
General information on the subject of room air dependent or room air independ-
ent operation:
The stove is supplied as a standard room air-dependent fireplace stove. This means
that the stove draws all of the combustion air from the installation room via the central
air intake on the back. A sufficient supply of combustion air (at full load approx. 25m³ /
h) is absolutely necessary.
In combination with ventilation and air conditioning systems (e.g., controlled ventilation
systems, fume hoods, etc.), Section 4 of the Firing Ordinance (FeuVO) is decisive in
Germany. The flue gas routing must be monitored by special safety devices (e.g., via
an approved differential pressure monitor) or, if a ventilation system is used, this must
ensure that no negative pressures greater than 4 Pa occur in the installation room com-
pared to the outside and that the necessary combustion air (approx. 25 m3 / h) for the
fireplace.
Please always observe - in consultation with your authorized district chimney sweep -
the applicable local regulations and rules. We cannot accept any liability for changes
made after this manual has been printed. We reserve the right to change without notice.
The above-mentioned safety devices are not a substitute for professional planning and
design of an adequate combustion air supply.
As part of the acceptance, the district chimney sweep must check the adequate com-
bustion air supply / overall installation.

2.6 Choice of flue gas and air connection placement

The following steps must be observed when converting the flue gas connection:
Pic. 5
Pic. 6
1- Detach the rear panel of the device by unscrewing the 6 screws (pic 6). Then lift
and remove the back panel.
29

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Gor188 17Sosa 188 17Gor 188 17

Inhaltsverzeichnis