Useful Tips - PNI Escort HP 8001L Benutzerhandbuch

Check the radio:
Once installed and powered from the vehicle's electrical system, do the following to verify its operation:
• Check that the radio is powered correctly
• Check the antenna connection to the radio
• Connect the microphone to the jack on the front panel of the radio
• Turn on the radio by rotating the volume knob clockwise and adjust the volume to the desired level
• Select the desired channel with the UP/DOWN keys on the front panel or on the microphone.
• Press the SQ button in the limit area where the background noise disappears.
Note: If the ASQ mode is enabled (by pressing the ASQ on the microphone) the SQ button can not be activated
• Press the PTT button on the microphone to emit, and release it to receive
• Check the signal level received via the signal bars on the front panel
• Turn the ASQ function on the microphone and adjust its level from the ASQ button on the front panel of
the station

USEFUL TIPS:

Do not reverse the polarity when powering the radio.
Do not replace the fuse with a higher value. The fone from the factory has 2A.
Do not emit without an antenna or a broken or not tuned antenna to avoid burning the CB output transistors.
Adjust the SQ and ASQ until the background noise disappears. By turning the SQ knob clockwise too much,
you will receive only the strong signals (those emitted nearby).
CHANGING THE STANDARD:
To change the standard of the radio, do as follows:
• Turn off the radio
• While holding down the Up and PTT buttons on the microphone, turn the radio on
• Use the up and down keys on the radio to select the desired standard
• Turn the radio off and back on
To check the current norm, repeat the same procedure.
Available norms:
Norm Frequency (MHZ)
EU
26.965-27.405
CE
26.965-27.405
26.965-27.405
-9
26.565-26.955
-U* 27.60125-27.99125
-P 26.960-27.400
-d 26.965-27.405
*In -U configuration, in order to select the frequency band CE, move the AM/FM switch to AM position. CE
shortly appears on the display. Move back to FM position, you are back in -U norm. -U shortly shortly appears
on the display.
Channels
40CH (4W) AM/FM
40CH (4W) FM only
01CH-40CH (4W) AM/FM
41CH-80CH (4W) FM only
40CH (4W) FM only
-5KHZ 40CH (4W) AM/FM
40CH (4W) AM/FM
7
Country EMG (19)
CH09: 27.065MHz AM/FM
EU
CH19: 27.185MHz AM/FM
RO, MT CH19: 27.185MHz FM
DE CH19: 27.185 AM/FM
UK CH19: 27.78125MHz FM
PL CH19: 27.180MHz AM/FM
DE CH19: 27.185MHz AM/FM
EN