Philips HQ406, HQ404 Bedienungsanleitung Seite 6

ENGLISH
8
C
C
C
C
4 Slide the shaving heads out of the retaining
frame and clean them one by one.
Do not mix up the cutters and the guards.
This is essential since each cutter has been
ground with its corresponding guard for optimal
performance. If you accidentally mix the sets up, it
could take several weeks before optimal shaving
performance is restored.
5 Clean the cutter with the short-bristled
side of the brush.
Brush carefully in the direction of the arrow.
6 Brush the guard.
7 Slide the shaving heads back into the
retaining frame and put the retaining frame
back into the shaving unit.
8 Put the shaving unit back onto the shaver.
For extra thorough cleaning, clean the shaving
heads by putting them in a degreasing liquid (e.g.
alcohol) every six months.To remove the shaving
heads, follow steps 1 to 4 described above. After
cleaning, lubricate the central point on the inside
of the guards with a drop of sewing machine oil
to prevent wear of the shaving heads.