The Handheld Transmitter Lcd - Dogtra 640C Betriebsanleitung

1. Attach the charging cables to both the transmitter and
receiver(s), as shown on page 45.
2. Plug the charger into a 230-volt wall outlet or if using
only for Lithium-Polymer batteries. When properly
plugged in, all indicator lights should glow red. During
the charging process, the unit will shut off. Once the
battery cable is unplugged from the unit after a full
charge, you will need to turn the unit on again before use.
3. The Lithium-Polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process. The red light will change into a steady green light
when the battery is fully charged (when you disconnect
restart the unit).
4. After charging, cover the battery charging receptacles
with the rubber plugs on the transmitter and receiver/
collar.
NOTE : Only use Dogtra-approved batteries, chargers, and
accessories for your Dogtra e-collars. When a charger is not
in use, disconnect it from the power source.

8. THE HANDHELD TRANSMITTER LCD

46
Turn the LCD backlight on and off with a short press of
the on/off button.
The LCD screen indicates the stimulation level (0-127).
The LCD battery life indicator shows 3 bars at full charge,
2 bars at medium charge and 1 bar when it needs to be
charge for your receiver, observe the LED indicator on the
receiver/collar.
Green = full charge
Amber = medium charge
Red = needs charge
Care for LCD Transmitters in Cold Temperature
In cold temperatures (minus 12 dregrees Celsius or below),
the Liquid Crystal Display (LCD) on your transmitter may
be dim or slow to respond. Wait until the display becomes
visible before selecting any training level. Even though
the LCD screen might be dim or slow to respond when
you push the Nick or Constant button, the transmitter will
still function properly. In the occurrence of extremely cold
weather, the LCD screen might take a moment to respond
causing the intensity level to freeze at that current level. In
this situation, if you turn the rheostat intensity dial, the level
on the screen may not change but the actual intensity from
the receiver/collar will change in agreement with the dial. In
this situation, it is ideal to either wait until your transmitter
is back to working order before emitting a correction, or
while holding the constant button down slowly turn the
Rheostat Intensity Dial while watching your dog's reaction.
Do not turn the Rheostat Intensity Dial at a rapid increase
because the receiver/collar will emit a static correction
based on the level of the Rheostat Intensity Dial, which
47