Ordering Replacement Parts; Technical Data - EINHELL 41.404.70 Bedienungsanleitung

Anleitung HR 200 SPK1:_
GB
or the machine itself.
¼
It is normal for the pump to leak a little; this is
necessary to avoid damage to the pump when it
is at a standstill.
Maintenance
Checking the water intake filter (Fig. 5)
Periodically check the intake filter in order to prevent
clogging, which could jeopardize operation of the
pump.
To do this, unscrew the connection coupling for the
water inlet hose from the device and clean the expo-
sed inlet sieve by placing it under running water.
Long periods of nonuse (electric pump)
If the machine is going to be stored for longer peri-
ods of time (i.e. over three months) in a room where
frost could develop, it is recommended that the
machine be filled with an antifreeze solution (similar
to the antifreeze solutions used for vehicles).
When the device is not used for an extended period
of time, lime deposits begin to form in the electric
pump, which in turn can lead to starting difficulties.
Electric motor
The electric motor is equipped with a motor circuit
breaker switch. When the motor starts to run hot, it is
cut out by this switch. Switch off the machine. Wait 5
- 10 minutes before using the device again. Try to
determine the cause of the fault. If the problem
repeats itself, please contact a customer service cen-
ter.

Technical data

Rated voltage: 230 V ~ 50 Hz
Power rating: 2200 watts
Working pressure:
System pressure (EW bar): max. 200 bar
Output:
Max. water inlet pressure:
L sound pressure level:
pA
L sound power level:
WA
Weight:
12
12.01.2007 13:52 Uhr

Ordering replacement parts

Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
120 bar
7 l/min
4 bar
84 dB (A)
95 dB (A)
23 kg
Seite 12