Connection Instructions - Cisco Linksys BUSINESS-Serie Bedienungsanleitung

Connection Instructions

1
2
3
4
5
6
7
8
24-Port 10/100 + 2-Port Ggabt Swtch + 2 MnGBIC
Get user manuals: See SafeManuals.com
Make sure all of the devices you will connect to the Switch are
powered off
Connect a Category 5 Ethernet network cable to one of the
numbered ports on the Switch
Connect the Ethernet Network Cable
Connect the other end of the Ethernet network cable to a computer
or other network device
Repeat steps 2 and 3 to connect additional devices
If you are using a Gigabit port, connect a Category 5e network cable
to a Gigabit port on the Switch, and connect the other end to a
Gigabit server or other network device
If you are using a miniGBIC port, then connect a miniGBIC module
to a miniGBIC port For detailed instructions, refer to the module's
documentation
NOTE: The miniGBIC ports are compatible with the MGBSX1,
MGBLH1, and MGBT1
Connect the supplied power cord to the Switch's power port Plug
the other end of the adapter into an electrical outlet
Power on the devices connected to the Switch Each active port's
corresponding LED will light up on the Switch
Congratulations! The installation of the Switch is complete.
Chapter : Installaton