Axis Communications P5676-LE Installationsanleitung Seite 3

This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested using a shielded
network cable (STP) and found to comply
with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause
harmful interference to radio communications.
Operation of this equipment in a residential
area is likely to cause harmful interference in
which case the user will be required to correct
the interference at his own expense.The product
shall be connected using a shielded network
cable (STP) that is properly grounded.
Contact information
Axis Communications Inc.
300 Apollo Drive
Chelmsford, MA 01824
United States of America
Tel: +1 978 614 2000
Canada
This digital apparatus complies with
CAN ICES-3 (Class A). The product shall
be connected using a shielded network
cable (STP) that is properly grounded. Cet
appareil numérique est conforme à la norme
CAN NMB-3 (classe A). Le produit doit être
connecté à l'aide d'un câble réseau blindé (STP)
qui est correctement mis à la terre.
Europe
This digital equipment fulfills the requirements
for RF emission according to the Class A limit of
EN 55032. The product shall be connected using
a shielded network cable (STP) that is properly
grounded. Notice! This is a Class A product. In
a domestic environment this product may cause
RF interference, in which case the user may be
required to take adequate measures.
Australia/New Zealand
This digital equipment fulfills the requirements
for RF emission according to the Class A limit
of AS/NZS CISPR 32. The product shall be
connected using a shielded network cable (STP)
that is properly grounded. Notice! This is a
Class A product. In a domestic environment this
product may cause RF interference, in which
case the user may be required to take adequate
measures.
Japan
この装置は、クラスA機器です。この装
置を住宅環境で使用すると電波妨害を引
き起こすことがあります。この場合には
使用者が適切な対策を講ずるよう要求さ
れることがあります。 VCCI ‒ A
本製品は、シールドネットワークケーブ
ル(STP)を使用して接続してください。ま
た適切に接地してください。
本製品は電気通信事業者（移動通信会
社、固定通信会社、インターネットプロ
バイダ等）の通信回線（公衆無線 LAN を
含む）に直接接続することができませ
ん。本製品をインターネットに接続する
場合は、必ずルータ等を経由し接続して
ください。
Korea
이 기기는 업무용 환경에서 사용할 목적
으로 적합성평가를 받은 기기로서 가정용
환경에서 사용하는 경우 전파간섭의 우려
가 있습니다. 적절히 접지된 STP (shielded
twisted pair) 케이블을 사용하여 제품을
연결 하십시오.
Safety
The product shall be grounded either through
a shielded network cable (STP) or other
appropriate method.
The power supply used with this product shall
have a rated output voltage within voltage
range of 20-28 V DC, and a max current rating
of 3.5 A.
The power supply used with this product shall
fulfill one of the following requirements:
•
Safety Extra Low Voltage (SELV) according
to clause 2.2 of IEC/EN/UL 60950-1 and
Limited Power Source (LPS) according
to clause 2.5 of IEC/EN/UL 60950-1 or
CEC/NEC Class 2 source of supply as
defined in the Canadian Electrical Code,
CSA C22.1 and National Electrical Code,
ANSI/NFPA 70
•
Class 1 electrical energy source (ES1) and
Class 2 power source (PS2) rated output
power limited to ≤100 W according to
IEC/EN/UL 62368-1
We recommend the use of Axis mains adaptor
PS-24.
We recommend the use of AXIS T8007 PS24
power supply.
When used with Power over Ethernet (PoE),
the Power Sourcing Equipment (PSE) shall
comply with IEEE 802.3af/802.3at and Limited
Power Source (LPS) according to clause 2.5 of
IEC/EN/UL 60950-1 or annex Q of IEC/EN/UL
62368-1.
We recommend the use of Axis PoE+ midspans
or Axis PoE+ switches.