Electrical Safety; Environmental Protection; Before Putting The Machine Into Operation; Starting The Engine - EINHELL 41.523.72 Bedienungsanleitung

Anleitung STE 2000_SPK7:Anleitung STE 3500 SPK1
GB
Secure the generator against shifting and toppling
during transport.
Place the generator at least 1m away from
buildings and the equipment connected to it.
Place the generator in a secure, level position. Do
not turn, tip or change the generator's position
while it is working.
Always switch off the engine when transporting
and refueling the generator.
Make sure that when you refuel the generator no
fuel is spilt on the engine or exhaust pipe.
Never operate the generator in rain or snow.
Never touch the generator with wet hands.
Guard against electric danger. When working
outdoors, use only extension cables that are
approved for outdoor use and which are marked
accordingly (H07RN..).
The overall length of the extension cables used
may not exceed 50 m for 1.5 mm
2.5 m 2 .
No changes may be made to the settings of the
motor or generator.
Repairs and adjustment work may only be carried
out by authorized trained personnel.
Do not refuel or empty the tank near open lights,
fire or sparks. Do not smoke!
Do not touch any mechanically driven or hot parts.
Do not remove the safety guards.
Do not expose the tools to damp or dust.
Permissible ambient temperature – 10 to + 40 °C,
max. altitude above sea level 1000 m, relative
humidity: 90 % (non-condensing)
The generator is driven by a combustion engine,
which produces heat in the area of the exhaust (on
the opposite side of the sockets) and the exhaust
outlet. You should therefore keep clear of these
surfaces because of risk of skin burns.
The values quoted in the technical data for sound
power level (L ) and sound pressure level
WA
(L ) are emission values and not necessarily
pA
reliable workplace values. As there is a
correlation between emission and immission
levels, the values are not a reliable basis for
deciding on any additional precautions which may
be needed. Factors influencing the actual user
immission level include the properties of the work
area, other sound sources etc., the number of
machines and other processes in the vicinity, as
well as the time span in which the operator is
subjected to the noise. Also, the permitted
immission level can vary from country to country.
Nevertheless, with this information the user is able
to make a better assessment of the dangers and
risks involved.
12
18.06.2007
All manuals and user guides at all-guides.com
Important: Use only normal, unleaded petrol as
fuel.

6. Electrical safety:

Electric supply cables and connected equipment
must be in perfect condition.
The generator is to be operated only with
equipment whose voltage specifications conform
with the generator's output voltage.
Never connect the generator to the power supply
(socket-outlet).
Use only totally insulated equipment.
Keep the cable length to the consumer as short as
possible.
2 and 100 m for

7. Environmental protection

Dispose of soiled maintenance material and oper-
ating materials at the appropriate collection point.
Recycle packaging material, metal and plastics.
8. Before putting the machine into ope-
ration
Check the fuel level and top it up if necessary
Make sure that the generator has sufficient
ventilation
Make sure that the ignition cable is secured to the
spark plug
Inspect the immediate vicinity of the generator
Disconnect any electrical equipment which may
already be connected to the generator
9. Operation

9.1 Starting the engine

Open the petrol cock (13) by turning it down
Move the ON/OFF switch (10) to position "ON"
with the key.
Move the choke lever (11) to position IØI.
Start the engine with the reversing starter (12) by
pulling the handle forcefully. If the engine does not
start, pull the handle again.
Push the choke lever (11) back again after the
engine has started.
7:39 Uhr Seite 12