Maximum Operating Time; Max. Operating Time; Fault Messages; Safety Cut-Off - infra world Saunacontrol T Montage- Und Gebrauchsanweisungen

Press the button in standby mode and the start screen will appear.
Hold the button for longer (2 sec.), the display shows "prog. pre-select OFF" (see item 8).
Press the button once. The display shows "max. operat time".
The operating time can be adjusted with the
Max. 6 hours in private operation, max. 12 hours in commercial operation (STANDARD EN60335-2).
prog. pre-select
max. operat time
By pressing the
"-pre-select active-" will appear).
In the case of sensor interruption, low water level and cover protection system response, the heating is switched
off immediately. The display shows the fault in the bottom display line.
sauna
temperature:
temp.-sensor
EN
If the cable connected to the operating or sensor unit is interrupted, the heating circuit is cut off immediately. In
addition to this, the cabin is provided with a safety temperature limit controller.
If the maximum temperature of 128 °C is exceeded, it means there is a defect and the sauna is switched off. In
this case, an expert must be consulted.
When the heater cover protection (rocker) is activated, the heating circuit is cut off immediately and the display
shows an error message.
30

9. MAXIMUM OPERATING TIME

OFF
02:00:00
button again, the controls change to the start screen (if "prog. pre-select = ON" is selected,

10. FAULT MESSAGES

01:25:30
Possible fault messages:
temp.-sensor ...
- - °C
safety sensor ...
! cover protection ! ...

11. SAFETY CUT-OFF

or button from 30 minutes to 20 hours in 10-minute steps.
interruption of the room temperature sensor
interruption of the safety limiter
heater cover protection system has been
activated