Preselection - infra world Saunacontrol T Montage- Und Gebrauchsanweisungen

Preselection may only be used with a cover protection system for the heater.
Press the button in standby mode and the start screen will appear.
Hold the button for longer (2 sec.), the display shows "prog. pre-select OFF", with the
change to "prog. pre-select ON".
prog. pre-select
start - time
operat. type
current time
max. oper. time
By pressing the button again, the adjustable features will be shown on the display one after the other:
1. "start - time" (selection only possible for the next 24 hours)
2. "operat. type" (preselection sauna)
3. Set "current time"
4. "max. oper. time" to be adjusted from 30 minutes to 20 hours
Set max. 6 hours in private operation, max. 12 hours in commercial operation according to
STANDARD EN60335-2.
By pressing the button once more, the controls change to the "pre-select active" mode.
-pre-select active-
start - time 18:00:00
operat. typ
current time 20:00:05
max. oper. time
The sauna controls are now in the "pre-select active" mode and switch on according to the adjusted time and
operating mode.
The pre-selected starting time can only be set within the next 24 hours.
The "pre-select active" mode is switched off again by pressing the
disconnecting rocker is activated, preselection is deactivated (according to STANDARD EN60335-2 -
Telecontrol).
8. PRESELECTION MODE
ON
To adjust the settings use the plus
18:00:00
and minus buttons
sauna
20:00:00
02:00:00
sauna
02:00:00
button. When the door contact switch or
button you can
EN
29