Vasco RF Anleitung Seite 19

RADIO CONFIGURATION MODE
!!! Note: All combinations of batteries and receivers have been
matched.
When this is not the case, please follow the below mentioned
steps.
Also when several receivers are controlled by just one thermo-
stat, the below mentioned steps have to be followed.
1. Make sure your thermostat is in OFF mode.
2. Make sure the receiver is on by positioning the receiver
button.
3. The LED on the receiver will turn green.
4. Next, press and hold the button on the receiver for 5
seconds until the green LED starts to flash.
5. Then set the thermostat to
thermostat will start to communicate.
mode. The receiver and the
Button
UK
19