Dometic WAECO CoolMatic CRP-40 Bedienungsanleitung Seite 31

CRP-40.book Seite 31 Montag, 27. September 2010 4:07 16
CoolMatic CRP-40
➤ Connect the refrigerator (fig. a, page 7)
– as directly as possible to the poles of the battery or
– to a plug socket which is fuse protected with at least 15 A (at 12 V) or
7.5 A (at 24 V).
Caution!
e
Disconnect the device and other consumers from the battery
before charging the battery with a quick charging device.
Over voltages can damage the electronics of the device.
For safety reasons the refrigerator is equipped with an electronic system to
prevent the polarity being reversed. This protects the refrigerator against re-
versed polarity when connecting to a battery and against short circuiting. To
protect the battery, the refrigerator switches off automatically if the voltage is
insufficient (see table below).
Cut-off voltage
Cut-in voltage
6.5 Connecting to a 230 V mains supply
Danger of fatal injuries!
d
Never handle plugs and switches with wet hands or if you are
standing on a wet surface.
Caution!
e
If you are operating your cooling device on board a boat with a
mains connection of 230 V from the land, you must install a residual
current circuit breaker between the 230 V mains supply and the
cooling device.
Get advice from a qualified specialist.
➤ To operate the refrigerator on the 230 V mains, use the WAECO MPS-35
rectifier.
All manuals and user guides at all-guides.com
Setting up and connecting the refrigerator
12 V 24 V
10.4 V 22.8 V
11.7 V 24.2 V
31