Connection; Output Connection - Renkforce RF 100 Bedienungsanleitung

Connection

Output Connection

Before connecting the device, ensure that the mains plug is disconnected.
Turn off all units that are to be connected and disconnect them from the mains supply.
Please observe the manufacturers' installation and safety instructions of all other devices that
are to be connected together.
Only use the included or other suitable connection lines for cabling. In doubt, contact an expert.
To avoid distortion or mismatched connections which could damage the record player,
connect only cinch outputs to cinch inputs.
Also observe the values stated in the "Technical Data".
The record player has a built-in phono pre-amplifier and thus does not require a device with phono input.
The PHONO/LINE (14) switch switches the built-in phono pre-amplifier on and off.
• Put the PHONO/LINE switch in the PHONO position if record player is connected to a phono input.
• Put the PHONO/LINE switch in the LINE position if record player is connected to a line-in input.
Never connect the audio line (4) to a phono input if the PHONO/LINE switch is in the LINE
position. The connected amplifier would strongly over-modulate in this case. This may cause
damage to the amplifier and the connected speakers.
Connect the audio line (4) to the input of the subsequent amplifier.
• Connect the record player's white cinch plug to the left channel.
• Connect the record player's red cinch plug to the right channel.
Connect the USB socket (13) to a free USB port of your computer.
26
Operating Instructions

English