Auto-Off Function; Preparing Your Hair - Imetec R9501 Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

Open the rubber cap (9) positioned on the rear of the reservoir

(8) making sure not to tear it when you do so.

Take the top cap off the bottle (12) and place the tip in the larger

hole of the water reservoir (8).

Fill the water reservoir (8), keeping it slightly tilted with the

rounded part facing downwards.

Close the rubber cap (9) and make sure that the tank (8) is

completely dry before putting it back in place.

Slide the reservoir (8) in its seat towards the front of the

appliance until you hear a "click". [Fig.B2]

ON / OFF

NOTE: Always keep the heating plates clean to ensure that

the straightener offers the best performance.

Connect the cable (7) to the power supply.

Switch the appliance on by pressing the ON/OFF button (5).

Select one of the 4 temperature values (170°C - 185°C - 200°C

- 230°C) by pressing the + or - button (4).

NOTE: The straightener features an electronic temperature

regulation system. This means that the temperature of the

straightener can be adjusted to suit the hair type:

170°C: recommended for fine hair

185°C: recommended for medium hair

200 - 230°C: recommended for thick hair

In case of doubts, always begin with the lowest temperature,

increasing it gradually until you find the ideal temperature.

The appliance is ready for use when the temperature shown on the

LED display (3) stops flashing and you hear two consecutive beeps.

After having selected the desired temperature, the button lock

can be activated by pressing the + button (4A) for a few seconds.

This function prevents accidental temperature changes while

using the straightener. The lock can be deactivated by pressing

the + button (4A) again for a few seconds.

When you have finished styling your hair, switch the appliance

off by pressing the ON/OFF button (5). Wait for the appliance

to cool down. Disconnect the plug and let the appliance cool

completely.