Before Starting The Equipment - EINHELL TH-OS 1016 Originalbetriebsanleitung

Sound and vibration
Sound and vibration values were measured
in accordance with EN 62841.
L sound pressure level ........................ 79 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 90 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 62841.
Vibration emission value a
K uncertainty = 1.5 m/s
The stated vibration emission levels and stated
noise emission values were measured in ac-
cordance with a set of standardized criteria and
can be used to compare one power tool with
another.
The stated vibration emission levels and stated
noise emission values can also be used to make
an initial assessment of exposure.
Warning:
The vibration and noise emission levels may vary
from the level specifi ed during actual use, depen-
ding on the way in which the power tool is used,
especially the type of workpiece it is used for..
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Limit the operating time!
All stages of the operating cycle must be conside-
red (for example, times in which the electric tools
are switched off and times in which the tool is
switched on but operates without load).
Anl_TE_OS_1016_SPK9.indb 15 Anl_TE_OS_1016_SPK9.indb 15
= 7.5 m/s
2
h
2
- 15 -
GB
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the dust bag (Fig. 2-3/Item 4)
•
Slip the dust bag (4) onto the dust extraction
connector (2).
•
The dust is extracted directly into the dust
bag through the abrasive paper and the oscil-
lating plate (5).
•
To empty the dust bag, open it and carefully
tap out the contents.
•
You can also connect the equipment by the
dust extraction connector (2) directly to a sui-
table vacuum cleaner (Fig. 3).
Important!
For health reasons it is imperative that you use
the dust bag or a dust extraction system.
5.2 Fastening the abrasive paper with the
hook-and-loop fastening system (Fig. 4)
•
Only use sanding/grinding paper of the ap-
propriate size and suitable perforations.
•
Place the sanding/grinding paper on the
oscillating plate (5) as shown in Fig. 4. Make
sure that the perforations in the sanding/grin-
ding paper line up with the oscillating plate.
18.09.2019 09:10:22 18.09.2019 09:10:22