USING
THE CLEANER
CONTROL PANEL
A - On/off switch
B - Detergent control tap.
STARTING THE CLEANER
1) Turn on the water supply
tap (fig. 4A).
2) Connect the water cleaner
to the mains electricity supply
via the omnipolar switch or
by plugging the plug into the
socket.
3) Start the cleaner by turning
the selector switch to pos. 1
(fig. 6A).
The high pressure water
jet generates a reaction force
!
in the lance. Keep a firm grip
on the lance handle.
4) Press the trigger on the gun
and begin washing.
In water cleaners with
the "Total Stop" system, the
!
motor starts and stops when
the lever on the lance handle
is actioned or released.
Do not block the handle
lever in the delivery position.
!
IMPORTANT!
To eliminate any impurities
or air bubbles from the wa-
ter circuit we advise starting
the cleaner for the first time
without the lance and letting
the water run out for a few
seconds.
Impurities could block the
nozzle and cause malfunc-
tion (Fig. 7).
All manuals and user guides at all-guides.com
English
STOPPING THE CLEANER
1)
rinse the high pressure water
circuit by operating the pump
for one minute with the deter-
B
gent tap completely closed.
A
(fig. 8).
2)
ning the selector switch to pos.
"0" (fig. 6A).
3)
FIG. 6
from the H.P. hose by pressing
the trigger on the gun (fig.
5A).
4)
cleaner from the mains electri-
city supply via the omnipolar
switch or by unplugging the
plug from the socket.
5)
tap (fig. 4A).
even temporarily, turn it off by
using the omnipolar switch or
by unplugging the plug from
the socket.
"Total Stop" device should be
considered as off when the
omnipolar switch is in the "O"
position or the plug is unplug-
ged from the socket.
is not used, close the safety
device on the handle (fig. 9).
ner causes serious damage to
pump gaskets.
FIG. 7
- 20 -
After use with detergent,
Stop the cleaner by tur-
Discharge the pressure
Disconnect the water
Turn off the water supply
If the water cleaner is left,
!
Water cleaners with the
!
When the water cleaner
!
Dry use of the water clea-
!
FIG. 8
FIG. 9