Franke FMA 607 WH/XS Bedienungsanleitung Und Installation Seite 9

Fitting the hood body
• Open the doors/the door (See section Open
Panels).
• Remove the Metal grease filters using the
handles provided.
• Adjust the two screws Vr, in the brackets 11a, so
that they are at the start of their travel.
• Hook the hood body to the two brackets 11a.
• From the inside of the hood body, turn screws Vr
to level the hood body itself.
• Fasten the safety screw 12a.
• Close the doors/the door again.
Air outlet – Recirculation Version
• Screw the filter cover onto the air outlet, using
four screws 12c (2.9 x 6.5).
• Fix the directional Grid 8 on the recycled air out-
let, using 2 screws 12d (2.9 x 9.5) provided.
• Open the Door/Doors (See paragraph Opening
Panels).
• Remove the Metal grease filters using the
handles provided.
• Make sure that the Activated charcoal odour
filter has been fitted.
Connections
AIR OUTLET - DUCTING VERSION
To install the hood in the ducting version, please
refer to the instructions provided in the ducting kit
specific to the hood.
EN
Vr
12a
12d
8
12c
16
11a
9
9