Installation - BOMANN EHBC 7935 IX Bedienungsanleitung, Garantie

1 Residual heat
indicator
2 Ø200 mm / 1800W
Delivery scope
1x standard oven tray
1x set of side rack

Installation

The built-in oven is designed for installation in stand-
ard kitchen units.
WARNING:
The installation and the connection to the main power
may only be performed by an authorized specialist.
CAUTION:
• The worktop, the cabinet, veneers, plastic coat-
ings, used adhesives etc. must be sufficient heat-
resistant (min. 100°C).
• To ensure a sufficient cooling air supply, no heat
protection strips may be installed.
• If there is a drawer below the furnace or it is at-
tached, an intermediate shelf is required.
3 Ø165 mm / 1200W
4 Ø200 mm / 1800W
5 Ø165 mm / 1200W
1x grill grid
2x mounting screws
NOTE: Recommendation!
• When installing, ask another person to assist.
• Wear protective gloves to avoid injuries at possi-
ble sharp edges.
• When inserting, use the recessed grips on the
side of the housing to lift the unit. Caution! Do not
carry or hold the appliance by the door handle.
• Do not install the appliance directly next to refrig-
erators or freezers. The heat dissipation will un-
necessarily increase its energy consumption!
• Before installation, check that the appliance and
furniture dimensions match.
• Hob and oven must be from the same manufac-
turer and marked with the same type of designa-
tion.
• The oven and hob must be positioned centrally to
each other.
Safety distances
CAUTION:
Make sure that adequate air circulations ensured,
and the ventilation slots are not blocked. Follow ap-
propriate safety distances!
• The appliance must be installed so that heat can
be dissipated. The ventilation openings must not
(see illustration).
be blocked
• Maintain sufficient distance behind the appliance
at the installation site so that the appliance can
work efficiently and well.
• The distance between the hob and the cooker
hood must be at least as large as specified in the
installation instructions for the hood!
26