Menu Button; Display Information - Levenhuk Halo 13X Helmet Bedienungsanleitung

Button panel and device settings
POWER button
Press and hold the POWER button for 3 seconds to turn the device on or off.
Turn the focusing wheel to adjust the focus.
Notes:
•
If the device fails to activate, check for defective or improperly installed batteries. Always only use the recommended batteries.
•
If you wear glasses, keep them on while using the device.
IR UP button
If the light is insufficient or when used in the evening, turn on the IR by pressing the IR UP button. The image will change from color
to black and white. You may select the brightness level from 1 to 7. The brightness values will be displayed on the LCD screen.
Button functions: 1) IR brightness level up; 2) Zoom in (long press); 3) scroll the menu up.
Notes:
•
Do not use IR in daylight (when IR is on, you will have a color image, when IR is off — black and white image).
•
If the battery power is not enough, the IR LED level will lower automatically. If only half power is left, the max. brightness level is
5. If only 25% power is left, the max. brightness level is 3. If the battery power is lower than 25%, the IR LED cannot be activated.
IR DOWN button
Button functions: 1) IR brightness level down; 2) Zoom out (long press); 3) scroll the menu down.
Note: IR illumination (infrared radiation) can be detected by photo and video cameras and similar electronic devices during
operation.
MODE button
This button switches between 3 in-built modes: 1) photo mode; 2) video mode; and 3) playback mode.
The default mode is video.

MENU button

To change the settings, press the MENU button and highlight the desired menu item by scrolling up (IR UP button) or down (IR DOWN
button).
Select the highlighted item by pressing the SHOT/OK button.
In the menu, you can select photo or video resolution, night vision sensitivity, change the language, set the date, set auto power off,
put the date on photos or videos, format the memory card, view and delete the current file or all files from the memory card, etc.
Note: To get to the submenu of the playback mode, you need to select the playback mode first (MODE button).
Long press the MENU button to take a picture with the luminous green effect or film color effect. Long press the same button again
to go back to the normal color mode.
Please note that the device can produce a color image, a black and white image, a bright green image, or an image with a color film
effect. However, the color image is not available when night mode is on.
SHOT/OK button
Button functions: 1) takes a picture in Photo mode; 2) starts and stops video recording in Video mode; 3) enters the sub-menu.

Display information

Current mode
Memory card
1
Indicating IR levels (1–7)
Captured image counter
Current image resolution
Night vision sensitivity
Battery status
Indicating the zoom in levels
Display brightness level
Current video resolution
5